How to Fill a Pod — Step by StepUpdated 15 days ago

Before You Fill

• Make sure the pod is empty or nearly empty before refilling — topping off a partially full pod is fine.
• Check that your e-liquid is the right type for your pod kit — balanced PG/VG (50/50 or 60VG/40PG) for most pod systems. Avoid very high VG liquids in pod kits.
• Have a paper towel handy for any drips.

Finding the Fill Port

The fill port is a small opening covered by a rubber plug or silicone seal. Common locations:

• Side fill: A rubber plug on the side of the pod — the most common design.
• Bottom fill: A plug on the bottom of the pod. Remove the pod from the device, flip it over, and fill from the bottom.
• Top fill: A plug or sliding mechanism on the top of the pod, accessible while the pod is in the device.

Step-by-Step Filling Instructions

1. Remove the pod from the device (for side and bottom fill).
2. Locate the fill port and open or remove the rubber plug.
3. Tilt the pod slightly to angle the fill port up.
4. Insert your e-liquid bottle tip directly into the fill port — press the tip against the inside wall of the fill hole, not down the center (this prevents air bubbles).
5. Fill slowly and steadily. Watch the clear pod window to monitor the level.
6. Stop filling when the e-liquid is just below the top — leave a small air gap. Never overfill.
7. Remove the bottle tip and firmly close or replace the fill port plug.
8. Let the pod sit upright for 5–10 minutes to allow the coil to fully saturate before vaping.

Needle Tip Bottles

If your e-liquid bottle has a wide tip that doesn't fit the fill port easily, transfer some liquid to a small needle-tip bottle (also called a unicorn bottle). These narrow tips fit any fill port cleanly and make filling much easier. We carry these at SmokTek.

Troubleshooting Fill Problems

• Liquid won't go in: Make sure the fill port is fully open and you're inserting at the right angle. Some ports require the pod to be tilted.
• Air bubbles / gurgling after filling: Let the pod sit longer before vaping, or gently tap the pod on a surface to dislodge bubbles.
• Leaking after filling: Most likely overfilled or the fill plug isn't fully sealed. Empty slightly and ensure the plug is firmly closed.